Wednesday, 30 April 2008

Faux Tearing Tutorial

Well, it's been a while since I updated the blog! Here's a tutorial for you.

Faux Tearing

Step 1 - tear a piece of scrap paper, eg photocopy paper and place over part of your card. This will be a mask for the part of the card you don't want stamped. Here I'm using Whisper White as my card panel.



Step 2 - ink up your chosen background stamp. Here I'm using the Paisley background stamp, and inking it with Perfect Plum stamp pad. Note I haven't covered the whole stamp as some of it won't be used, so I'm trying to save on ink. I find it easier to get coverage on the background stamp by rubbing the ink pad on the stamp rather than dabbing.


Step 3 - stamp onto the partly covered up card. With a large stamp or background stamp you may want to rub your hand over it to ensure you get even coverage.



Step 4 - carefully lift off your stamp to reveal your image. You will have an image on part of the card with a slightly rough looking edge where the torn paper was covering up the card.



Step 5 – line up your torn piece of scrap paper with the image, leaving a small gap. Then with a sponge dauber, using the same ink colour (Perfect Plum) as you used for the background stamp, dab along the edge, as shown.






Step 6 – remove your scrap piece of paper to see how you’ve gone.










Step 7 – put the card panel onto a card base and add embellishments to finish your card.



Products Used, all Stampin Up!:
Stamp Sets: Paisley Background Stamp, Polka Dots & Paisley for the flower and sentiment
Perfect Plum cardstock for the base card
Whisper White cardstock for the panel
Elegant Eggplant cardstock for the 2 smaller stamped images
Whisper White Craft Stampin Pad for the flower and sentiment
Perfect Plum Classic Stampin Pad for the background stamp
Basic Black ¼ inch Grosgrain Ribbon
Sponge Daubers

Happy stamping!




No comments:

Post a Comment